Trays of colorful microgreens growing under an LED bar grow light on a shelf.
17

Nov

Growing Microgreens Under LED Lights

Microgreens go from seed to harvest in one to three weeks, take up a single shelf, and sell well. They’re also one of the best-studied crops under LED lights. Here’s what the research says about lighting them.

The basic cycle

University of Maryland Extension describes the routine:

  • Blackout: keep trays covered for the first few days after sowing, until the seeds sprout.
  • Light: uncover and grow under lights for about 16 hours a day.
  • Harvest: cut at 2–3 inches tall, usually 7–21 days after sowing, depending on the crop.

How much light microgreens need

Growers measure a day’s light as the daily light integral (DLI), in moles of light per square meter per day.

Purdue University researchers (Craver and Lopez) grew microgreens at DLIs of 6, 12 and 18 under LEDs, 16 hours a day. More light gave:

  • Shorter, sturdier stems
  • More color (more anthocyanin, the red-purple pigment)
  • More harvest weight per tray

The catch: more light costs more power. Going from a DLI of 6 to 12 doubled the lighting energy; going to 18 tripled it.

Cornell research found a DLI of up to about 9 works for arugula, while mizuna and mustard kept improving at 12 and above, and higher light got crops to harvest about two days sooner. Maryland notes higher light also raises the healthy compounds (phenolics) in the greens.

A good target for most microgreens: a DLI of about 9–12.

Turning DLI into a light setting

At 16 hours a day:

PPFD = DLI ÷ (16 × 0.0036)

DLI targetPPFD at 16 hours
6about 105 µmol/m²/s
9about 155
12about 210
18about 310

That’s far less than a full-power grow light puts out. An Edisun FXL-320 over a 2×4 ft shelf delivers roughly 860 µmol/m²/s at full power, so for microgreens you’d run it at about a fifth to a quarter of full power.

Setting up the light

  • Hang it at least 12 inches above the trays. Older guides say 6–12 inches, which suits weak fluorescent tubes. A modern LED is brighter, so keep the distance and dim it instead. Every Edisun light dims to 10%.
  • Use a timer for a steady 16-hour day. See grow light schedules.
  • Shelves and racks: a linear bar like the Edisun FXL spreads light evenly across standard 10×20 trays, shelf after shelf. See the rack setup guide.
  • Humidity: trays are watered daily, so pick a fixture rated for damp spaces. Edisun lights are IP66. See what IP65 means for a grow light.

What it costs to run

Because microgreens need low light, the power bill is small. An FXL-320 dimmed to about a quarter draws roughly 80W. At 16 hours a day and $0.15/kWh, that’s about $6 a month per shelf. Try your own numbers in our running cost calculator.

Quick checklist

  1. Sow, cover for a few days until the seeds sprout.
  2. Uncover under a light set to about 155–210 µmol/m²/s, 16 hours a day.
  3. Turn the light up for crops that should be shorter and more colorful; down to save power.
  4. Harvest at 2–3 inches, 7–21 days after sowing.

Setting up a microgreen rack? See Edisun LED grow lights, or ask us how many fixtures your shelves need.


Sources

Leave a Reply

Your email address will not be published. Required fields are marked *

RELATED

Posts