Racks of lettuce and basil under LED grow light bars, with a tablet showing a simple chart in the foreground.
20

Nov

DLI Calculator: Daily Light Integral Explained

Daily light integral (DLI) is the total amount of plant-usable light your crop gets in a day. It’s the single most useful number for setting up a grow light, because it combines how bright the light is with how long it runs.

DLI = PPFD × hours × 0.0036. Scroll or tap to load the calculator.

The formula

DLI (mol/m²/day) = PPFD (µmol/m²/s) × hours of light × 0.0036

The 0.0036 converts seconds to hours (3,600) and micromoles to moles (÷ 1,000,000).

To work backward from a target:

PPFD = DLI ÷ (hours × 0.0036)

Example: lettuce under a light delivering 200 µmol/m²/s for 16 hours gets 200 × 16 × 0.0036 = 11.5 mol/m²/day.

DLI targets by crop

Michigan State’s Erik Runkle publishes these general targets in mol/m²/day:

CropTarget DLI
Leafy greens and herbs (lettuce, basil)12+
Fruiting vegetables (tomatoes)15+
Cut flowers15+
Potted flowering plants12+
Bedding plants10+
Seedlings and plugs6–10 early, 10–15 late
Foliage and shade plants6–10

Runkle stresses that these are “subjective and situational,” not hard requirements. Aim for at least the minimum; going far above it often isn’t worth the power, except for fruiting crops, where yield keeps climbing with more light. Some lettuces get tip burn when DLI is too high.

For specific crops, see our guides to seed starting and microgreens.

Hours vs. intensity

The same DLI can come from a brighter light for fewer hours or a dimmer light for more hours:

DLI target12 hours16 hours18 hours
10230 µmol/m²/s175155
12280210185
15350260230
20465350310

Longer days at lower intensity usually cost a little less in fixtures and can be gentler on plants, but some crops flower or bolt in response to day length. See grow light schedules.

Where does PPFD come from?

  • Measure it at the canopy with a quantum (PAR) sensor.
  • Estimate it from the spec sheet: average PPFD ≈ PPF × 0.75 ÷ area in m². See PPF vs. PPFD.

Once you know your target PPFD, set it with the dimmer rather than by moving the light. See when to dim your grow light.

In a greenhouse

Sunlight supplies most of the DLI, and grow lights fill the gap on short, cloudy days. Subtract the sun’s contribution and size the lights for what’s left. See greenhouse supplemental lighting.

Planning a grow? See all Edisun LED grow lights, check your power bill with the running cost calculator, or ask us for a layout.


Sources

Leave a Reply

Your email address will not be published. Required fields are marked *

RELATED

Posts